Jump to content

Auto Numbering


woodman78

Recommended Posts

I have setup standard notes for my office. They are imported as blocks (see the attached image). I have the block setup on a few layers as follows:

Black Text (note): OFFICE_NOTES

Red line and circle: OFFICE_NOTES_SETUP

I have a lisp to toggle on and off the setup layer. This layer is only used to position the note on the layout and to position the numbering of the notes.

 

I have been using LeeMac's AutoNum to number the notes but have had problems when others use it. I am wondering if someone can write me a lisp that will place a number at the centre point of each of the circles within blocks on the OFFICE_NOTES_SETUP layer starting at the top of the drawings and working down along.

 

Thanks

note.png

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...