Inserting image!!!!

Hello,

Can anyone please tell me the method to insert image in a particular picture in autocad!

I wanted to insert am image of brick work, in a circular design on the wall (elevation), in cad...But was unable to do so.

Use the ._ImageAttach command.

Thank you, but is there some short cut command for it!

Command: IAT

I tried doing as you directed, but the image is coming in rectangular shape, not in a circular or L- SHAPE boundary.

You will have to use the ._ImageClip command, or the Express Tools command "ClipIt".

Tip: For ._ImageClip, use a multi-sided (±200 sides) polygon for a 'circular' clipping shape.

Draw a circle over the image then use the Express Tool ->Modify -> Extended Trim command.

I dont know, but i am just not being able to get it right.

Thank you, for all your suggestions, but it somehow, isnt helping me.

I dont know, but i am just not being able to get it right.

Thank you, for all your suggestions, but it somehow, isnt helping me.

Take a look at this animation.

Yes, now i got it

Thank you so much,4 taking the pain to explain me the method via this animation clip.

Thanks for the nice video but i cant get it to clip using the circle.I only have the "Enter clipping type [Polygonal/Rectangular]" choices.

Thanks for the nice video but i cant get it to clip using the circle.I only have the "Enter clipping type [Polygonal/Rectangular]" choices.

I did not use a circle. Watch the command line during the animation and you will see that I used a multi-sided polygon.

As explained earlier in this thread, you can use a circle if you use the Express Tools command "ClipIt", but you end up with the same result, because the actual clipping object in either case will be a multi-sided polyline.

Say suppose, i need to insert an image within an irregular boundary, how can i do that!

You might want to take a look at the Express Tools SUPERHATCH command.

Say suppose, i need to insert an image within an irregular boundary, how can i do that!

Pay attention to the prompts of the ._ImageClip command. You can select any closed polyline to clip the image.

Hmm.. this tutorial about circular images was posted on 10 July

http://www.cadtutor.net/forum/showthread.php?t=50221

Hmm.. this tutorial about circular images was posted on 10 July

 

http://www.cadtutor.net/forum/showthread.php?t=50221

Yes, I figured I would try and reach a wider audience...

Thank you all for the answers.

Thank you, so much.....