Cat Posted July 22, 2010 Share Posted July 22, 2010 Does anyone know if there is a command line prompt for the Add Attribute function? I'm writing a script and haven't been able to find any reference to it in my reference material. Thanks Quote Link to comment Share on other sites More sharing options...
Ste1978 Posted July 23, 2010 Share Posted July 23, 2010 Type '-ATT' in the command prompt? Quote Link to comment Share on other sites More sharing options...
Cat Posted July 23, 2010 Author Share Posted July 23, 2010 No, -ATT is the same as -ATTDEF which defines an attribute. The command I'm attempting to invoke actually adds an attribute to a predefined block, but thanks for trying. Quote Link to comment Share on other sites More sharing options...
Cat Posted July 25, 2010 Author Share Posted July 25, 2010 I've come to the conclusion that the task I was trying to accomplish can't be done with a script because the "utility" within the command "Add Attribute" is not currently supported. If the I/O modules had been assembled in a "block" format as opposed to "parametrically" built, it would have been as simple as updating the affected blocks and replacing them throughout the Project. It's a rare circumstance that you would ever have to do that at the end of a job, but on the rare occasion that you might, it sure is less expensive to be able to, as opposed to manually manipulating each I/O module. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.