break arcs & circles with 5mm gap - No 2

sorry made a mess of my first post it should of said =

Hi i'm looking for some help with a routine, i need it to find all circles and arcs in a drawing and put a break (gap of 5mm) in each, i need it to know the lengths of the arcs & circles so that it would then know how many gaps each arc & circles need.

for example a length of 20mm to 50mm would have 1 5mm gap and 51mm to 100mm would have 2 5mm gaps and 101mm to 150mm would have 3 5mm gaps.

i do have one which was just for line which works well if need i could put it on this post.

thanks

jimpcfd

Try CAB routine. (I did it and it is now on my toolbar-thanks Alan)

http://www.cadtutor.net/forum/attachment.php?attachmentid=6363&d=1214064770

Many Thanks will try it out this weekend.

hi mdb design - well i tried this routine out, and it works well but it's not what i'm after, i needed it to put a gap in arcs and circles please see attached dxf file.

i have one that does line only.

can anyone one help please ?

thanks

jimpcfd

5mm gaps arcs and cricles.dxf

If you look at CAB routine there is gap setting on the left to Help button. Change it to desire gap and try all three options.