Removing triangual polygons on side faces of 3-D solids usin

[Jabba]

I know there is a variable for this but I just can't remember it!!
When extruding a profile from a region, and then viewing it in isometric and then using the HIDE command, you get a nice view of your model but you also get the triangualr polygons making up the extruded profile.
I know FACETRES increases the number of polygons visible, but can anyone tell me the variable, probably found in SETVAR, that makes these polygons dissapear.
Thanx.

[f700es]

I know there is a variable for this but I just can't remember it!!
When extruding a profile from a region, and then viewing it in isometric and then using the HIDE command, you get a nice view of your model but you also get the triangualr polygons making up the extruded profile.
I know FACETRES increases the number of polygons visible, but can anyone tell me the variable, probably found in SETVAR, that makes these polygons dissapear.
Thanx.

Try DISPSILH and set to 1 (0 is default). Maybe step up FACETRES a bit as well. I believe the default there is .5 maybe try 1. Good luck and let us know how you make out.

F7

[Jabba]

Many, many thanx F700ES for your reply. It works a treat!