Bottle Model

I have some problems with a model of a bottle

1st I can't make a bottle with thickness wall and emboss with the brand or a diferent form than simple bottle.

2nd cant decal the bottle when i make the bottle like a solid.

Somebody can help me whit this problem please!

cant upload the model cause it too big for upload in the forum but i upload a image of the bottle

the form of the emboos its like the gatorade bottle.

i use inventor 2011 thanks

how did you create the part? i would have revolved and shelled it out to give it its wall thickness. then follow with the embossing.

i was create the part like this

first i create a part 2 with a loft comand then emboss the sketch

second make parte 1 and 2 whit a revolve

third put a decal but how you can see the decal its incomplete.

i try to emboss the part 1 like gatorade bottle but the program say's that i cant cause its not a plane or cilindrical feature.

you can project an embossment onto a surface or make it follow a profile it sounds like u have no reference selected for it to emboss on to. not too sure on the decal front...

cant upload the model cause it too big

Find the red End of Part marker in the browser.

Drag the EOP marker to the top of the browser hiding all features.

Save in a rolled up state. (this will make the file much smaller - make sure you haven't embedded the image files - attach them separately)

Zip and attach the file here.

thank you very much for the tip. this is the model

BOTELLA UNICOLA 1 NO DECAL.zip

and this is the decal

i was put the decal in a jpg but in the model is in bmp

First thing I noticed is that your sketches are not constrained.

You might read this document.

http://home.pct.edu/~jmather/skillsusa%20university.pdf

Then I noticed that you are doing too much work.

The first Loft could have been made with a simple Revolve. In fact, the entire profile of the bottle could have been one Revolve.

Do the details except the thread, and Shell. (Actually, there is no thread and the top is not modeled correclty)

WorkAxis4 is a duplicate of the Z axis and not needed (along with several workplanes).

Your part is partially surface bodies? and solid body?

Sketch4 is missing tangent constraints and in general poorly done. Only need single side for Shell.

thank you for the pdf material. i was doing the loft cause when i try to make the emboss in the revolve i cant select a face like the jumex sketch. i will read the entire pdf format and refine the model. then will upload again.

hello friends i was refine the sketch and the result is this but i still have problemen whit the shell comand and the emboss

this is the file

REFINE FOR FORUM.zip