rdharvey Posted October 1, 2010 Share Posted October 1, 2010 Is there a feature in inventor to do a boundary blend like pro e where 2 sketches can be selected and it will blend the two shapes with a solid and the the running profiles can be edited after? Or is there only the lofting command? Thanks Quote Link to comment Share on other sites More sharing options...
rdharvey Posted October 1, 2010 Author Share Posted October 1, 2010 Right scrap that i figured my sketch was open, next question how can you check that your sketch is a closed loop? Pro e had a function where it pin pointed where the sketch is not connected. How do i do that on inventor? Thankkss Quote Link to comment Share on other sites More sharing options...
JPlanera Posted October 1, 2010 Share Posted October 1, 2010 right click when in sketch mode, select sketch doctor. This will tell you any problems that need to be resolved with the current sketch Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.