Vj Posted November 11, 2010 Posted November 11, 2010 I am bothered by the following in AutoCAD LT 2011. Suppose there is a line measuring 'X'. In earlier versions, one could grab the end grip and reduce the length of the line by entering Y in the command line so that the new length became 'X' minus 'Y'. Now this operation results in a line of length 'Y'! Is there any toggle/command line switch which can restore the earlier behavior? Quote
designerstuart Posted November 11, 2010 Posted November 11, 2010 i had this same problem with the full version here http://www.cadtutor.net/forum/showthread.php?51610-setting-dynamic-input-default-length-change-not-resulting-dimension i'm sure there is a way to change it....... but unfortunately, i don't know the answer! Quote
ReMark Posted November 11, 2010 Posted November 11, 2010 I don't see any reason why AutoDesk would have changed that feature. It should still work even in LT. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.