BurnetCAD Posted November 16, 2010 Share Posted November 16, 2010 When trying to align 3 separate solids in an assembly, the one I am adjusting starts spinning and then dissapears, the screen freezes for a millisecond and then my entire assembly dissapears except for the center points. Can anyone help with this? Thanks....... Quote Link to comment Share on other sites More sharing options...
JD Mather Posted November 16, 2010 Share Posted November 16, 2010 Attach the assembly here. Quote Link to comment Share on other sites More sharing options...
BurnetCAD Posted November 16, 2010 Author Share Posted November 16, 2010 How do you attach a file to the quick reply? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted November 16, 2010 Share Posted November 16, 2010 Right click on the folder that contains the assembly and select Send to Compressed (zipped) folder. (you might need to roll up the End of Part marker in the part files first to get the file size as small as possible) When you respond here click the Go Adanced button and then Attach the *.zip file here. Quote Link to comment Share on other sites More sharing options...
BurnetCAD Posted November 18, 2010 Author Share Posted November 18, 2010 Trying to align cable lug to connect to cu. lead hook in container box. The lug was brought in and copied 2 times (there are 3 lead hooks for 3 phases). The lug was constrained but alignment could not be achieved without the previously mentioned problems. SurgePak 2011 Problem.zip Quote Link to comment Share on other sites More sharing options...
JD Mather Posted November 18, 2010 Share Posted November 18, 2010 Of course (just like the real world) an assembly without any parts is useless. Quote Link to comment Share on other sites More sharing options...
BurnetCAD Posted November 18, 2010 Author Share Posted November 18, 2010 Did you receive the assembly without parts? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted November 18, 2010 Share Posted November 18, 2010 Did you receive the assembly without parts? One iam file - no ipt files in the zip. Quote Link to comment Share on other sites More sharing options...
rdharvey Posted November 19, 2010 Share Posted November 19, 2010 same here.. Quote Link to comment Share on other sites More sharing options...
BurnetCAD Posted November 30, 2010 Author Share Posted November 30, 2010 Here are the step files:roll:. I hope this works. step files.zip Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.