can't plot multiple copies

[Andrew]

No matter how many times I change the "number of copies" number from one to any other number, I only get 1 copy.

I have changed it by using the up and down arrows and I have also highlighted the number and changed it, but it will still only give me 1 copy.

My new number will still be there when I hit the "ok" button, but again only one copy comes out of the plotter.

I am running autocad 2006 and an HP 755CM plotter.

I have even re-installed the plotter drivers and it doesn't make a difference.

Any Advice?

[hazardman]

i've ran into this problem before...assigning the # of copies has to be the verry last thing you set before hitting the plot button...i haven't used 2006 so i don't know if it's the same "bug" in your case....

[Kate M]

Are you plotting to a file?

[Andrew]

No I am plotting to a plotter.
I have even tried what hazardman suggested and it doesn't help.
This morning I even tried setting the number of copies in the plotter configuration editor, and saved it as a temporary .pc3 file, it didn't work either.