Jump to content

Dimension extension line offset


abishop

Recommended Posts

So, if you have 2 Diameters you are dimension in a section view. You are dimensioning them horizonally not with a leader line. The 2 diameters are really close to each other, so in your drawing your extension lines are just about on top of each other. How do you JOG or offset the extension line to point and see the dimension better?

Thanks

AndyB

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...