Jump to content

Tangent constraint. contact set and spring action for device!


Mobileinventor

Recommended Posts

I was able to get a tangent constraint for the plunger inside of the cylinder but not with the air check valve and the small hole on the end of the cylinder.

 

I also set the plunger and cylinder as contact sets and changed the document settings to account for contact sets but it doesnt work and my update button is missing too.

 

How do I insert a spring so when the plunger is pushed inside the cylinder then a spring is compressed.

 

Many thanks for your help!

 

Vacuum Tube.zip

Plunger.zip

Cylinder.zip

VPump.zip

pump.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...