Jump to content

Sheet metal question


barrsurf

Recommended Posts

I need to attach 18 ga sheet metal to the inside curve of two of these battens spaced 24" apart. Could someone point me to a good tutorial on how to do this? I know there are some curve issues and I've separated it into 2 parts, (the curve) but that seems a very poor solution. Also, in trying to stress analyze it the sheet metal is too thin to mesh. Any suggestions are greatly appreciated.

 

Thanks

 

Inventor Professional 2011

batten.zip

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...