SOliver Posted April 15, 2011 Share Posted April 15, 2011 Hi folks, For all who use acad for 3d modelling and either use an old version or have turned ribbon mode off I offer the following as a quick method for chanigng 3D view without the need for that pesky toolbar start by pressing alt, v, 3 in sequence and follow with one of the following. t = top f = front k = back b = bottom l = left r = right n = north east w = north west s = south west e = south east. Hope someone puts it to good use. Quote Link to comment Share on other sites More sharing options...
Joseph Marquez Posted July 23, 2011 Share Posted July 23, 2011 Oh thanks! I was looking for a quicker way to do that! Quote Link to comment Share on other sites More sharing options...
WKJA Posted September 15, 2012 Share Posted September 15, 2012 I'm new for this & i like it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.