Original Settings Restore

Is there anyway to restore my original settings. A master switch if you will. I think that might solve the problems I am having with my points not being recognized by the Parcel Command and Line Command

LAND DESK

Thanks,

Joe M

Is there anyway to restore my original settings. A master switch if you will. I think that might solve the problems I am having with my points not being recognized by the Parcel Command and Line Command

 

LAND DESK

 

 

Thanks,

 

Joe M

Start AutoCAD with a new profile (copy the shortcut on the desktop, right click, properties,Shortcut tab, in the Target line after the first statement in quotes you may have a /p profile_name, over write that if it is there with /p newprofile (pick any name that doesn't already exist in your profile folder), and if you don't have a /p profile_name then simply add the /p newprofile to that line. Pick ok, then double click on the icon, AutoCAD will start with the new clean profile

"C:\Program Files\Land Desktop 3\acad.exe" /p "C:\Program Files\Land Desktop 3\lddt.arg"

RKENT,

This is what I found there is would be so helpful if you could tell me what to change it to.

We could use a Moynihan about now.

Thanks,

Joe M.

Is there anyway to restore my original settings. A master switch if you will. I think that might solve the problems I am having with my points not being recognized by the Parcel Command and Line Command

 

LAND DESK

This sounds to me like a Land Desktop Project / Prototype issue... perhaps cgx.dfm, or points.mdb? Just a guess.

"C:\Program Files\Land Desktop 3\acad.exe" /p "C:\Program Files\Land Desktop 3\lddt.arg"

 

RKENT,

 

This is what I found there is would be so helpful if you could tell me what to change it to.

 

We could use a Moynihan about now.

 

Thanks,

 

Joe M.

I didn't notice you were using Land Desktop, my suggestion will start autocad without the land desktop addons.

It can't hurt anything so change the shortcut copy and try it out, see below.

"C:\Program Files\Land Desktop 3\acad.exe" /p defaultprofile

Thanks A lot

I moved this to the Civil3D & LDD forum.