magnetic grips

[BITDRAUGHTY]

Hello ,

Can anybody tell me why my grips are acting like to positve magnets that repell each other?

I am tyring to move a grip to a grip and they just swerve each other at the last minute?very annoying!

[CarlB]

That action may depend what running osnaps are set. Toggle them off (F3 button) and see it behavior changes.

[BITDRAUGHTY]

No it seems to make it worse ??i know this is really strange it is not even my computer low on memory or anything like that ?

It gets really bad when i zoom in and just cannot seem to move it within a 500mm radius of any grip?

I have taken out my layer filters, purged it, audited it, kicked it, shouted at it, it still does not seem to want to work?and it is a relativly small drawing of about 1500 kb so it all seems a little strange.

[Cad64]

Is it just in that one drawing?

If it's only that drawing:
Did you create it or did it come from an outside source?
If it came from outside, do you know who or what software created it?

[profcad]

Do you have SNAP turned on?

[BITDRAUGHTY]

Well i have tried it with on or off and neither worked.

I have now solved the problem and was quite longwinded in doing so.

I copied each layer to another drawing pasting with the original cooridinates until the drawing was back to normal and hey presto no more magnetic grips.

It appears that 2 extra layers had been created from somewhere called default and c50 these had to be erased in 2006 and decreased the drawing size considerably once deleted seeing as they had nothing on them?

Thank you for your help and suggestions

B draughty