Jump to content

Tube paths not populating


rogle

Recommended Posts

Hi

 

Im having a problem with the tubing and pipe feature in inventor 2012. I can create a run easily enough but I cannot get it populated to show the hose. I am using hydrolic hose with no fittings which by default I believe is 1/2 inch diameter. An error message comes up saying that the sweep failed but the path is not complex enough to make it fail. Im wondering if there are any settings I need to play with to get it correct as I am still using default

 

hose path.jpg

 

Thanks

Link to comment
Share on other sites

Yea well I dont listen to you very often cos you chat crap :D. I find it weird that it will do it for paths more complicated than this yet just collapses when its presented with an easier path

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...