Jump to content

Rotation and Joint Fit Issues


nicolas

Recommended Posts

Hi,

 

I encountered two tremendous problems today namely

 

1. I have a nylon joint to fit into an alu. traverse and the joint is slightly bigger than the traverse. In real world, this is not a problem, it had to be pressed or lightly squeezed into the traverse. Also, I have to lightly force the glazing into the joint and the latter taking form around the extremity of the glazing. Where should I start, given that I have no idea at all how to takle this issue?

 

Joint Issues.pdf

 

2. Also in assembly everything was going fine when at the last minute, I am constraining plane-to-plane and one of the object keep rotating prior to effecting the mate.

 

Answers to those will be great. Thank you in advance.

 

Regards,

 

Nicolas.

Edited by nicolas
Attachment Missing
Link to comment
Share on other sites

You will have to model the two different states - Inventor is not going to automatically deform the solids for you.

For the second question you will have to attach the assemby here.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...