Viu Posted October 5, 2011 Share Posted October 5, 2011 Hello, I'm trying to derive a part for a nested cut, however when I attempt this the other part isn't visible and doesn't show up as a solid. If I try it the other way around it says "Selected component was rejected since it causes a cyclic dependency." Thanks for your help, Viu Quote Link to comment Share on other sites More sharing options...
JD Mather Posted October 5, 2011 Share Posted October 5, 2011 Zip and attach the file(s) here. Quote Link to comment Share on other sites More sharing options...
KAOMOMAK Posted October 13, 2011 Share Posted October 13, 2011 I do have similar problem. It is with deriving blocks. After i derive block i can't move or rotate. Block is fixed and i can't see how to edit. I did it in Inventor 2010 without any problems, but now i just start with 2012 release. Any help would apreciate. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted October 13, 2011 Share Posted October 13, 2011 Any help would apreciate. Zip and attach files here. Quote Link to comment Share on other sites More sharing options...
KAOMOMAK Posted October 13, 2011 Share Posted October 13, 2011 Thanks for such quick response TEST DERIVE BLOCK.ipt Quote Link to comment Share on other sites More sharing options...
JD Mather Posted October 13, 2011 Share Posted October 13, 2011 I don't see the original file - only the derived file? Quote Link to comment Share on other sites More sharing options...
KAOMOMAK Posted October 13, 2011 Share Posted October 13, 2011 That was just test file, i create to see how is working but i figured out how it is working. I made mistake in derive block process. I appreciate your very quick respond. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.