fle Posted October 7, 2011 Posted October 7, 2011 I had to reinstall my Acad 2011 yesterday after reformatting my HD. All was working well, then this morning after looking for the express tools in the CUI then closing out of the CUI command, I noticed that several commands were no longer working. E.g., within the standard toolbar, the Properties button displayed: "_properties Unknown command "PROPERTIES". Press F1 for help." A few additional commands within the same toolbar gave me a similar message ( Match Properties, Sheetset ) while the rest of the buttons on the toolbar worked fine. I also get a similar message for all the buttons on my Osnap toolbar. I then tried typing the commands on the command line as well as closing reopening Acad... same message. I'm guessing I may find the same problem on other toolbars. I sure don't recall messing with anything that would cause this. Any suggestions for getting my commands back? Quote
ReMark Posted October 7, 2011 Posted October 7, 2011 A glitch in the install process might be addressed via the REPAIR option. Quote
fle Posted October 7, 2011 Author Posted October 7, 2011 Where do I get to the Repair option? I downloaded and installed directly from Autodesk versus from disk. Quote
ReMark Posted October 7, 2011 Posted October 7, 2011 It is part of the Windows Add/Remove Programs found in your Control Panel. You downloaded the necessary file(s) from AutoDesk to your hard drive then you installed the program right? Any problems during the download? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.