Viu Posted October 20, 2011 Share Posted October 20, 2011 [ATTACH=CONFIG]30638[/ATTACH] Can anyone show me how to checker a part in Inventor, like the one shown? -Thanks, Viu Quote Link to comment Share on other sites More sharing options...
JD Mather Posted October 20, 2011 Share Posted October 20, 2011 Loft to point. Rectangular pattern or use a cosmetic texture. Quote Link to comment Share on other sites More sharing options...
Viu Posted October 25, 2011 Author Share Posted October 25, 2011 Thanks, however I'd like something a little more tutorial-ish. Making the actual knurling is the only option as I want to have this part produced. Quote Link to comment Share on other sites More sharing options...
SLW210 Posted October 25, 2011 Share Posted October 25, 2011 Thanks, however I'd like something a little more tutorial-ish. Making the actual knurling is the only option as I want to have this part produced. What type of machine needs the drawing to show the actual knurling? Did you check out the tutorials in JD Mathers signature? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted October 25, 2011 Share Posted October 25, 2011 Make an attempt at modeling the geometry. Attach your attempt here (right or wrong). Quote Link to comment Share on other sites More sharing options...
JD Mather Posted October 26, 2011 Share Posted October 26, 2011 Did you figure out how to loft to a point yet? Pattern feature? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.