abishop Posted November 4, 2011 Share Posted November 4, 2011 I want to change the length of an NPT thread on a face of a revolved cut NOT on a hole feature. I have a lot of things going on in this port and that is why i did not use the hole feature. Thanks AndyB Quote Link to comment Share on other sites More sharing options...
Bishop Posted November 4, 2011 Share Posted November 4, 2011 When you do the thread feature, there's a check box for "full length." Un-check that, and you can change the length of the threaded section, and the offset from the end. I haven't played with it too much, but I think that the offset is from whichever end of the face was closest to where you clicked when you selected the face to be threaded. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.