Jump to content

Polyline join doesn't want to join with arc?


Furion

Recommended Posts

Hello.

 

Drawing:

line, arc, line.

 

arc was defined with line's end points and radius, so I'm positive that this drawing is continous.

 

Steps I take:

pedit

click

do you wish to turn into polyline

y

j

Select objects: 1 found

Select objects: 1 found, 2 total [enter]

Select objects:

0 segments added to polyline

[enter]

 

What am I doing wrong? I had no problem turning other arcs into polyline...

 

cheers

Furion

Link to comment
Share on other sites

First convert the arc to polyline then connect at least one end point of a polyline and after choosing the join option give the fuzz value 0.0 and

they would be connected .

 

Good luck :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...