deRabes Posted February 8, 2012 Share Posted February 8, 2012 Hi I have a cylindrical part with holes to be drilled around the circumference. I have a work plane set at the front and at the back and want to position one at about 50 degrees off the front work plane. Can someone run me through the process involved? Thanks again in advance New.ipt Quote Link to comment Share on other sites More sharing options...
JD Mather Posted February 9, 2012 Share Posted February 9, 2012 Your WorkAxis1 is a duplication of the Z axis and not needed. Your hole sketches are not constrained and too much work (could do with one sketch). To create angled workplane create sketch on XY plane with line at desired angle to desired plane location. Exit sketch. Create workplane at endpoint of angled line by selecting the endpoint and the line. Quote Link to comment Share on other sites More sharing options...
deRabes Posted February 9, 2012 Author Share Posted February 9, 2012 All taken on board. Will do Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.