lic2kill Posted February 8, 2012 Share Posted February 8, 2012 I would like to put bearings and dist on my lines but my line and tables says that nothing else. How do I get the whole ribbon to come up? Quote Link to comment Share on other sites More sharing options...
BlackBox Posted February 8, 2012 Share Posted February 8, 2012 Welcome to CADTutor! If the Ribbon is in fact off (read closed), then simply use the RIBBON Command to display the Ribbon again. Hope this helps! (HTH) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.