RRS1987 Posted February 11, 2012 Share Posted February 11, 2012 Dear All, I have been made one load schedule for distribution panel by using table command in autocad. In that table, I have to mention load with units(watts) for each circuit in cell. (example: 6000w). If I put like 6000w in a cell, the sum formula's is not working. These formula's used to get total load of panel. what should i do to rectify this problem? how to mention this units in a cell? thanks in advance. Quote Link to comment Share on other sites More sharing options...
the ber Posted February 11, 2012 Share Posted February 11, 2012 If I understand you correctly, you are trying to add non-numerical strings. Can you make an extra cell for just the letter "w"? Then you can have a cell with the "number" 6000, and an adjacent cell with the "letter" w. Quote Link to comment Share on other sites More sharing options...
Jack_O'neill Posted February 11, 2012 Share Posted February 11, 2012 Perhaps you could put the unit in the column header similar to this: LOAD (Watts)? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.