MemberX Posted February 20, 2012 Share Posted February 20, 2012 I'm trying hard to overcome this problem.I want to draw the door in plan but the arc is coming in other direction.here is sample drawing. Drawing1.dwg Quote Link to comment Share on other sites More sharing options...
Tiger Posted February 20, 2012 Share Posted February 20, 2012 Draw the arc in the other direction; use what you had as endpoint previously as Startpoint now. This is one of the quirks of AutoCAD, arcs only go one way (mostly) :wink: Quote Link to comment Share on other sites More sharing options...
MemberX Posted February 20, 2012 Author Share Posted February 20, 2012 Oh my .thanks tiger...... it is so easy ...I have wasted half an hour to solve problem Quote Link to comment Share on other sites More sharing options...
nestly Posted February 20, 2012 Share Posted February 20, 2012 Sometimes there isn't anything to snap to at that end of the arc, so you can still pick the original point, then specify a negative angle Command: _arc Specify start point of arc or [[color=red]Center[/color]]: [b]C[/b] Specify center point of arc: Specify start point of arc: Specify end point of arc or [[color=red]Angle[/color]/chord Length]: [b]A[/b] Specify included angle: [b]-90[/b] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.