Jump to content

Editting Border Definition


vertical horizons

Recommended Posts

I want to redefine the TITLE BLOCK in an .IDW.

 

If I right-click on ANSI-LARGE, and select EDIT DEFINITION, I can see where there is one line where the TITLE goes, but I want to be able to have 3 lines in the title block.

 

How do you redefine the title block so that it will allow you to have 3 lines in there, instead of one line?

 

I suppose I could copy the

text and place it above and under the original one, but then I would have no way to edit the two additional lines.<p> </p> <p>I do not want to use ANNOTATE to place text into the TITLE BLOCK area. I am sure that there is a proper way to accomplish this.</p>
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...