Jump to content

hatch problem


mateen

Recommended Posts

hi i have one of the drawing have hatch problem the problem is that my solid are not shown in print but other hatch are shown in printing only soild hatch are not showing i check fill command my fill is on and also check fillmode my fillmode is set to 1 i really to0 much confuse about that.... plz reply thanks advance

Link to comment
Share on other sites

Please check that the shade plot mode is set to Wireframe or As Displayed (PLOT command --> Shaded viewport options).

 

Regards,

Mircea

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...