mateen Posted March 5, 2012 Share Posted March 5, 2012 hi i have one of the drawing have hatch problem the problem is that my solid are not shown in print but other hatch are shown in printing only soild hatch are not showing i check fill command my fill is on and also check fillmode my fillmode is set to 1 i really to0 much confuse about that.... plz reply thanks advance Quote Link to comment Share on other sites More sharing options...
MSasu Posted March 5, 2012 Share Posted March 5, 2012 You have checked the state of layer that contains that hatch - to don't be set as "no plot"? Regards, Mircea Quote Link to comment Share on other sites More sharing options...
mateen Posted March 5, 2012 Author Share Posted March 5, 2012 i have checked my layer plot. my plot is on .... Quote Link to comment Share on other sites More sharing options...
MSasu Posted March 5, 2012 Share Posted March 5, 2012 Please check that the shade plot mode is set to Wireframe or As Displayed (PLOT command --> Shaded viewport options). Regards, Mircea Quote Link to comment Share on other sites More sharing options...
mateen Posted March 5, 2012 Author Share Posted March 5, 2012 Thank u soo much dear...... I solved problem when i select as as displayed..... Thanks msasu Quote Link to comment Share on other sites More sharing options...
MSasu Posted March 5, 2012 Share Posted March 5, 2012 Good to hear that is solved. You're entirely welcome! Regards, Mircea Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.