clipper392 Posted March 16, 2012 Share Posted March 16, 2012 I have been looking at the Design Content function in AutoCAD 2012 and was wondering why if the content to be inserted says it is bolt side profile 10mm x 50mm. Why it doesn't come in at those dimensions when scale factor of 1 is set. It is't until I use a Scale Factor of 1.0162 that the profile comes in at the correct scale. Thanks for any suggestions. Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 16, 2012 Share Posted March 16, 2012 Could it be that you are inserting a metric bolt into a drawing set up to use imperial units? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.