Jump to content

Why can't I see my text in MLEADER while typing?


bwalter1025

Recommended Posts

So I recently upgraded from AutoCAD 2008 LT to 2013 (a huge jump), and I'm now tying to use MLEADER command.

 

When I create a new leader, the text I create for it does not display on screen or even in the command line while I am typing, which means I have an absurd number of typos, I'll get distracted mid-sentence and forget where I was, etc.

 

This is bad. I'm assuming there's some sort of system variable that turns this on and off?

 

Possible relevant info: leader scale is set to "annotative," leader style is "MTEXT."

 

Please help!

Link to comment
Share on other sites

I use 2011 and this has happened to me a lot. All I can figure to do is close drawing and re-open, this seems to work until it happens again.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...