LIST IN INCHES

[jnjavier]

I AM DRAWING IN INCHES USING DIRECT ENTRY. WHEN I VERIFY THE LINES USING THE LIST COMMAND I GET DESCRIPTION IN FEET. IWOULD LIKE TO SEE DESCRIPTION IN INCHES. IS THERE A COMMAND THAT GIVE ITS DESCRIPTION IN INCHES. THANKS..

[hyposmurf]

Surely if your units are set to inches,then the length of the objects displayed by the list command would be in inches.Units are units just that,if you change the units to cm's then 11 units would be 11cm,change the units to inches and the same line would be 11 inches.Try not to write posts in caps,as it's meant to be the equivalent of shouting :)

[Flores]

Type "ddunits" at the command line, and for the type, either choose fractional or decimal.

Flores