Jump to content

Need help to find volume


Shibuboss

Recommended Posts

I did post a response not sure where it went anyway if you have civ3D then its easy if not then there is free Civil design software out there serach previous posts eg EZYSURF

Also you have circles in your dwg you just need 3dpoints. BUT to get a vloume you need to compare 2 surfaces even if one is flat.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...