Demtor Posted September 22, 2012 Posted September 22, 2012 Hello everyone! I have a problem. I scanned a sketch of horizontals on my computer and now I need to get those lines to autoCAD somehow. Is there a way to import image and try to copy the way horizontals go or I will have to do everything manually? Quote
ReMark Posted September 22, 2012 Posted September 22, 2012 You can bring the scanned image in using the IMAGEATTACH command. Quote
BIGAL Posted September 23, 2012 Posted September 23, 2012 You can rescale image also, if the lines are units long say steps of 10, then set SNAP to 10 when drawing over top gives a bit simpler control to draw correct length. Quote
iainlines Posted September 24, 2012 Posted September 24, 2012 If you're drawing over the top then save the scanned image as a .TIFF rather than a pdf, bit nicer quality Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.