ali888
13th Jun 2006, 07:28 am
Hi,
I was wondering if anyone might be able to help me here. I have a dxf drawing that is produced by the mapinfo (not sure if anyone familiar with it). I was trying to open it up using AutoCAD LT 2005 and i could see the drawing there. However, i was told that there are some label texts there telling what lines they are for. All i could see was lines but no texts there. Then, i went to check if that layer is turned on but there is only one layer i.e. layer 0. I asked the creator of the dxf drawing to include the text when exporting to dxf in mapinfo software. They said they had done it. I was wondering if there is a conflict or anything that hinders these from appearing in autocad LT 2005.
Thank you very much in advance
I was wondering if anyone might be able to help me here. I have a dxf drawing that is produced by the mapinfo (not sure if anyone familiar with it). I was trying to open it up using AutoCAD LT 2005 and i could see the drawing there. However, i was told that there are some label texts there telling what lines they are for. All i could see was lines but no texts there. Then, i went to check if that layer is turned on but there is only one layer i.e. layer 0. I asked the creator of the dxf drawing to include the text when exporting to dxf in mapinfo software. They said they had done it. I was wondering if there is a conflict or anything that hinders these from appearing in autocad LT 2005.
Thank you very much in advance