sloped floors?

[Tara]

I am preparing a 3D floor plan and have to show sloped floors coming up from the floor level to the raised door openings. I cannot figure out how to do this.. please help!!!

[CADTutor]

Your question is a little difficult to answer without a bit more information. There are lots of ways this could be done, depending on particular circumstances. However, one way would be to use a 3DFace. Construct the 4 corner points of your sloping surface and then use OSNAPS to draw the 3DFace.

[gcp310]

Or if you are using solid modelling, use the wedge tool.
it will ask for dimensions on the command line.
once you have crated one wedge you can then mirror,then boolean modify
your ramp to have side returns with the same paramaters.