cad_monkey
31st Jul 2006, 03:46 pm
(I put this in the beginners section but am not getting very far)
Hi there,
I'm having a problem that i hope someone knows of a solution to.
I am using Autodesk Map 3D 2006 on WinXP.
The problem is, on very few drawings I go to import a layout (a company layout that i use on most drawings i receive without a problem), and the layouts contents resizes itself to beome larger than it should be. So the layout itslef (the white peice of paper) is the corret size, but the layouts contents dwarfs it.
I have looked into page setup and all the obvious things but i'm a bit stuck now. I used to just copy the model to a fresh new 'clean' drawing and create the layout in that, which would usually work. This time however, the drawing has an embedded image pasted into it which messes everything up, ie, it's now too big for the layout...
Anyone have a clue what's going on here?
Thanks
Hi there,
I'm having a problem that i hope someone knows of a solution to.
I am using Autodesk Map 3D 2006 on WinXP.
The problem is, on very few drawings I go to import a layout (a company layout that i use on most drawings i receive without a problem), and the layouts contents resizes itself to beome larger than it should be. So the layout itslef (the white peice of paper) is the corret size, but the layouts contents dwarfs it.
I have looked into page setup and all the obvious things but i'm a bit stuck now. I used to just copy the model to a fresh new 'clean' drawing and create the layout in that, which would usually work. This time however, the drawing has an embedded image pasted into it which messes everything up, ie, it's now too big for the layout...
Anyone have a clue what's going on here?
Thanks