Region

[sentinel]

Hi,

When I am clicking on draw / region (acad2006) I am having the error as follows:

Fatal error: Unable to load modeler DLLs.

[fahim108]

Did it work previously... or have you tried it for the first time?

If it did, try using Windows System Restore... :shock: may sound strange, but it does work good enough for these silly dll errors!

Best of luck! :)

[sentinel]

i have tried it for the first time

[fahim108]

Well, I'm afraid then! :cry: ...maybe reinstalling the software would be the only solution for you. See if that works... :unsure:

By the way, I had the same issue with the Fog command in AutoCAD 2007. Reinstalling helped me! :)

[Ako]

It sounds like you have got an installation problem. Try installing it again over the top of the existing program and see if that works. If not you will have to uninstall the program completely first then install it again.

Dave

[Galingula]

control panel

add remove hardware

(go to the autocad)

(choose "repair installation")

If it asks for the disk put it in

Enjoy

[sentinel]

I tried everything as was suggested above but with no success!

Now I am encountering another problem!!!!!!

I uninstalled AutoCad2006 and when I am trying to reinstall it it is telling me that I still have Acad installed.

When I looked in Program files there is nothing there but when I looked into Add/remove programs, Acad is still showing there with 354mb!

What am I going to do cause I need to run this program so badly!

thanks in advance