Mary E Posted December 4, 2013 Share Posted December 4, 2013 In my titleblock on the top right was a title NOTES. I defined it in attributes but when I typed in the text it would type over the word NOTES. The other attributes in the block titled Marys titleblock work fine. I tried deleting it from the attribute manager and then adding the attribute tag back - no luck even after syning it. I have been working on this for a while and I am missing something. I attached the file to this question so you can see it. Thanks Mary E Marys titleblock 24x36.dwg Quote Link to comment Share on other sites More sharing options...
Tuns Posted December 4, 2013 Share Posted December 4, 2013 I think I figured out what you're talking about. Is this what you're wanting it to look like? Marys titleblock 24x36.dwg Quote Link to comment Share on other sites More sharing options...
Mary E Posted December 5, 2013 Author Share Posted December 5, 2013 Thank you for responding so quickly. I am not able to open the drawing because it was corrected with a later version than I have. It says to open in trueview from autodesk. I cant seem to locate it. Do you know how to do this Thank you Quote Link to comment Share on other sites More sharing options...
SLW210 Posted December 5, 2013 Share Posted December 5, 2013 You can get DWG TrueView HERE. Quote Link to comment Share on other sites More sharing options...
Tuns Posted December 5, 2013 Share Posted December 5, 2013 My bad. I always forget to save it in an older format. This one is saved in a 2010 format so it should open. Marys titleblock 24x36.dwg Quote Link to comment Share on other sites More sharing options...
Mary E Posted December 5, 2013 Author Share Posted December 5, 2013 I did open it and that is what I was trying to do. Can you explain how you added the NOTES as an attribute. Did you have to explode the block first? Thank you Mary Quote Link to comment Share on other sites More sharing options...
Tuns Posted December 5, 2013 Share Posted December 5, 2013 It isn't an attribute, it's text. I copied the text from one of the other sections further down, pasted it, then just changed the text to "Notes". After that I just put an attribute in the center of your notes section for whatever notes you'd like to add. Of course you can replace the attribute I placed in there with a multi-line attribute if you want to write multiple lines of text like in the one below. Marys titleblock 24x36.dwg Quote Link to comment Share on other sites More sharing options...
Mary E Posted December 5, 2013 Author Share Posted December 5, 2013 Thanks so much for all your help Quote Link to comment Share on other sites More sharing options...
Tuns Posted December 5, 2013 Share Posted December 5, 2013 Any time. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.