Bill W Posted March 6, 2014 Share Posted March 6, 2014 The basic axis angle for iso drawing is 30 degrees; is it possible to change this angle? Specifically, I would like to draw several wood panels in a more "edge on" perspective, for an assembly view. Thanks much Bill Quote Link to comment Share on other sites More sharing options...
rkent Posted March 6, 2014 Share Posted March 6, 2014 Use Polar settings, pick any angle you like. What I am saying is to not go into iso mode, just set an angle you are after, like 45 degrees and let polar tracking do the work. Quote Link to comment Share on other sites More sharing options...
Bill W Posted March 7, 2014 Author Share Posted March 7, 2014 Thanks, everyone for your help. Had no idea I could use polar setting. However, I just went ahead with the pre-set iso settings. Came out looking OK so far, in spite of my inexperience. How do you like Albuquerque, rkent? Bill Quote Link to comment Share on other sites More sharing options...
rkent Posted March 7, 2014 Share Posted March 7, 2014 ......How do you like Albuquerque, rkent? Bill I like it very much, I have been here since 1966 so I have watched it grow. Family and friends are here so it is home. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.