Forum: Autodesk Inventor

Hello people! I have problem with fillet as you can see it on picture. Can't figure problem out. Do you have any idea why this is happening, since this is tenth (similar) part i have done. File...

surely someone out there has gotten annoyed enough with the lack of autosave feature in inventor that they've written some vba code to do the job. how hard would it be to set a timer (15mins say) so...

I have the beginning and ending elements of a tube. It seems like I should be able to loft the cross sections to create a tapered and offset tube. With rails selected I sometimes get the inner...

Hi, First, excuse-me for my english, I'm french ;) I try to import IFC in Inventor. I know that it's not directly possible, but do you know how to do it ? I tryed with Autocad Architecture, but...

Hello everyone, Happy New Year, I am modelling a manifold and stuck at a point where I need to route a pipe from weldolet. Ideally I would place the weldolet on the main header and start the route...

I'm a bit new to Inventor and created a basic sheet metal part with flanges and am receiving the error message "Could not split between bend and plate..." Could someone help with this?

I found this wonderful tutorial on YouTube but try as I might, I cannot get a certain part of it to work as they show it. The presenter draws two perpendicular lines and then trims them to form a 90°...

Greetings, Image 1, shows a Work Plane on the OD of the inner core solid, a Work Plane on the ID of the outer core solid, and sketches to produce a solid vane with the Lofted Flange command. ...

On attached screenshot I try to add radius 1909,8 + height 150, But It do not work. I have tried mm, ul and deg but It doesent allow me. What I do wrong?

I've got a customer who has drawn a 45° angle as 225° I don't know why, but I wanted to draw it that way to please them. I can't figure out how to do it. Any suggestions? Inventor 2017

Hi All, Can anybody help with the following. I have thousands of these tiles to produce in different sizes. The only variables will be the length, currently 660mm, the width, currently 220mm and...

Hi, I've modelled a part for my motorcycle and, for reasons that aren't important, need to mate it to a 2nd part in an assembly that represents the geometry of the top steering yoke on the forks....

Hello, I've been drawing on this basic design off and on for weeks and finally gave up and came to ask for help. What I'm trying to do is take a simple shape, a truncated pyramid, and design sheet...

Hello, I am working on an iLogic form where i can define the size of a gusset plate as shown in the picture. I am stuck at one point where i want a combo box in ilogic form with 3 options...