Jump to content

Help in drawing this two figures


KharizzaJeh

Recommended Posts

I have a problem drawing this two figures, it seems that it doesnt have the complete dimensions... can anyone help me draw this or teach me instead..?

Untitled.jpg

Link to comment
Share on other sites

  • Replies 49
  • Created
  • Last Reply

Top Posters In This Topic

  • KharizzaJeh

    20

  • ReMark

    13

  • JD Mather

    11

  • dbroada

    3

Top Posters In This Topic

Posted Images

Is this a class assignment?

 

Are you drawing the isometric view only or do you have to draw all the standard views (top, front, and side)?

Link to comment
Share on other sites

At first glance your drawing looks pretty good but there are a couple of things I need to check.

 

Of the four holes that penetrate the base two are supposed to have a 9mm diameter and the other two a 8mm diameter. You have one hole at 9mm and the other three at 8mm.

Link to comment
Share on other sites

I think there is enough information there but you will need to use the TANGENT snap. (I only do 2D so I may have missed something in the other view).

 

Part.jpg

Link to comment
Share on other sites

i also tried doing the 2d, but i cant figure out where will i Find the dimensions of the upper left side of the figure

Link to comment
Share on other sites

ReMark and I have interrpreted it slightly differently (I think he is more correct than me) in where we have positioed the large curve.

 

As for the left side, you can position both holes wrt each other which gives you the outside shape. Start by putting the holes down.

Link to comment
Share on other sites

Tangent to R14 and passing through 36.

If you use Constraints (parametric tab) this will be solved for you.

 

I don't think there is a planar face between the two. (therefore no line)

Back in a bit to check it closer.

Tangent.PNG

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...