jaff Posted March 22, 2017 Share Posted March 22, 2017 I've been trying to use FIND & REPLACE dialog box (please see attached). I tried using a lot of different options talked about in the web and had no luck. Did you have any success? I am using ACAD 2017 LT. Thanks, Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 22, 2017 Share Posted March 22, 2017 FYI - The thread you resurrected is nine years old and most of the respondents no longer participate in the forum. I doubt you'll be hearing from them. The only solution that seemed to work was posted by ASMI but it was a lisp routine. Unfortunately since you use LT the routine is of no use to you. Quote Link to comment Share on other sites More sharing options...
SLW210 Posted March 23, 2017 Share Posted March 23, 2017 I created a new thread in the AutoCAD LT Forum. FIND & REPLACE fractions Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.