ReMark Posted April 3, 2017 Share Posted April 3, 2017 You're entirely welcomed. Addendum. This just came to mind. Perhaps you should try creating the helix in Fusion 360. I haven't the time right now to pursue it myself. Quote Link to comment Share on other sites More sharing options...
OMEGA-ThundeR Posted April 4, 2017 Share Posted April 4, 2017 It probably is the small unit scale that is the problem. i had something similar a while back. Scaled it up and gone were al the blocky edges. http://www.cadtutor.net/forum/showthread.php?99260-Why-does-my-render-look-like-crap&highlight=omega-thunder Quote Link to comment Share on other sites More sharing options...
wezzo18 Posted April 6, 2017 Author Share Posted April 6, 2017 i fixed my problem. it was just because it was too small. if you take the a normal spring and scale it down more and more you can see how it gets less smooth the smaller it gets. Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 6, 2017 Share Posted April 6, 2017 Hmmm. Sounds familiar. Ah yes, post #17. "I think it may have something to do with the extremely small dimensions you are utilizing." Curious. What were you creating that you needed a spring with such small dimensions? Quote Link to comment Share on other sites More sharing options...
wezzo18 Posted April 6, 2017 Author Share Posted April 6, 2017 yes that was the exact issue... but that shouldn't be an issue right?(just curious) Quote Link to comment Share on other sites More sharing options...
Patrick Hughes Posted April 6, 2017 Share Posted April 6, 2017 Curious. What were you creating that you needed a spring with such small dimensions? My best guess: DNA Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 6, 2017 Share Posted April 6, 2017 yes that was the exact issue... but that shouldn't be an issue right?(just curious) Shouldn't but it is. Not much you or I can do about it. What were you attempting to create? Quote Link to comment Share on other sites More sharing options...
wezzo18 Posted April 7, 2017 Author Share Posted April 7, 2017 im not sure if you have heard of a diffuser? if you go onto the internet and search "AAP KZN" and look at profducts you will see what i am talking about. but basically i am creating a 3D model of all of the products. Quote Link to comment Share on other sites More sharing options...
wezzo18 Posted June 14, 2017 Author Share Posted June 14, 2017 i need help again Quote Link to comment Share on other sites More sharing options...
ReMark Posted June 14, 2017 Share Posted June 14, 2017 i need help again Don't we all. Without any specifics it would be impossible to provide a satisfactory answer. Quote Link to comment Share on other sites More sharing options...
Dana W Posted June 16, 2017 Share Posted June 16, 2017 Hard to draw something smaller than your pencil point. (your pixels) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.