Jump to content

Fillets after or as part of a union command


Nick1940

Recommended Posts

Use the FILLET command and pay close attention to what is being asked of you on the command line. This may take some trial and error if you have never filleted a 3D model before. Don't worry though. It gets easier as you do more of the same type of work.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...