samifox Posted April 26, 2017 Share Posted April 26, 2017 hi using acad 2010 and 2017, my drawing suddnly switch to snapemode (F9) but the official snap mode is turned off, only when i close and open the drawing again its ok but after 3 minets the problem come again. in 2017 i can control it with some of the new snap features. any idea? Quote Link to comment Share on other sites More sharing options...
RobDraw Posted April 26, 2017 Share Posted April 26, 2017 You need to be aware of exactly when it happens and what you were doing when it happened. Most likely causes are a LISP routine or OIE. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.