SOliver Posted May 3, 2017 Share Posted May 3, 2017 Hi all I am hoping to create a block which has two components, a drafted entity and a set of attributes. The thing is, I need to make it so that when you rotate the entity the attributes remain horizontal, below the entity. Is this possible? Thanks, SOliver. Quote Link to comment Share on other sites More sharing options...
OMEGA-ThundeR Posted May 3, 2017 Share Posted May 3, 2017 Looks like an simple 'rotation' action with only selecting the entity to rotate would to the trick? test.dwg Quote Link to comment Share on other sites More sharing options...
SLW210 Posted May 3, 2017 Share Posted May 3, 2017 I moved your thread to the AutoCAD Drawing Management & Output Forum. Check the Similar Threads listed at the bottom of this thread, it may provide you some ideas. Quote Link to comment Share on other sites More sharing options...
Ski_Me Posted May 4, 2017 Share Posted May 4, 2017 When you create your block and add the attributes make sure the attributes are annotative. This way they will maintain their horizontal reference to the x-axis. Next insert a rotate parameter to the block, then a rotate action and select everything. Your not done just yet, place a point parameter for each attribute you have in the center of each attribute. Apply a move action and select just the points and attributes. You will have to tweak this a little to get the attributes to behave like you want them too by moving the point parameter around a bit. If you get confused use this block as a reference. Notification Wall Mount System Sensor.dwg Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.