Jump to content

Multi Leaders and Neat Arcs


ASH_CAD

Recommended Posts

I am YouTube'd out:? so please help a Newbie

 

I want to know the best way to draw lines between say ceiling spot lights on a plan drawing. It's always a bit hit and miss as to the curve of the line.

 

Then at the final spot light, continue the lighting circuit line with a matching spline but with an arrowhead pointing in the direction of the source of the lighting circuit.

 

J

Link to comment
Share on other sites

Mleader splines never seem to go the way I want them to. When it absolutely, positively has to look a certain way, I explode the multileader and adjust the pieces.

 

CyberAngel gets schooled again in 3 2 1

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...