kippax Posted June 15, 2017 Share Posted June 15, 2017 Have to do this quite often, but unlike when editing a block, I can't find a "save as" option. Using ACAD LT 2015. Quote Link to comment Share on other sites More sharing options...
rkmcswain Posted June 15, 2017 Share Posted June 15, 2017 By edit in place, do you mean you are using the REFEDIT command? Quote Link to comment Share on other sites More sharing options...
tmelancon Posted June 30, 2017 Share Posted June 30, 2017 If you are talking about REFEDIT then you should see REFCLOSE. See attached image. If you mean that you accidentally x'ed out of that little toolbar while REFEDITING, then type REFCLOSE . This should save and get out of REFEDIT. You can then proceed to run REFEDIT again to step back in and your toolbar should know be visible. Hope this helps. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.